APPLICATION INSTRUCTIONS
- Properly Prep vehicle by washing with Feynlab Pure Wash or Feynlab Pure Rinseless
- Clay and Paint Correct surface if necessary
- When vehicle is ready to coat, make sure it is located in a well-lit, well-ventilated area that is between 50°F – 85°F (10°C – 30°C).
- BEFORE COATING – Shake the bottle VIGOROUSLY for one minute. Then, apply enough THE ORIGINAL CERAMIC to a microfiber sponge applicator to fully cover a single panel such as a door or half a hood.
- Begin by making a “+” (plus) sign in the middle of the panel and follow that with a picture frame around the area you are coating. Next, fill in the remaining panel in straight lines from left to right and then cross-hatch up and down, making sure to create a level layer with even coverage.
- Allow the coating to sit on the panel until about 75% dry, or until you see “rainbows”, similar to an oil sheen on water. This is a good indicator you are ready to move on to the next step.
- Once you are ready to move to the next step, use a clean microfiber towel (edgeless is recommended) and remove the remaining 25% of the unevaporated coating. Use a second clean microfiber towel to wipe clear if needed. You will begin to feel the towel glide easier and easier across the surface as the product is completely removed.
- Repeat the above process panel by panel (or multiple panels if your conditions allow) until the entire vehicle is coated.
- One layer of THE ORIGINAL CERAMIC is sufficient to achieve the one-year warranty, but additional layers may be applied to areas where additional protection is desired, such as leading edges, hoods, etc. Wait at least one hour between layers, but no more than 3 hours.
https://youtu.be/Gvc0LaBRQN8?si=-3s8tmShqigYN-cL
0 comments